Pinwall Dyno Test

[[email protected]]

I was browsing around on ebay and pulled up a part from Pinwall and see that they had dyno'd the bike before dissassembly.

http://www.pinwallcycle.com/ebay/bike2399/bike2399dss.jpg

90HP/ 159 ft lbs

Wonder what kind of mods the PO did to pull those #'s :biglaugh:

 

[dannymax]

I was browsing around on ebay and pulled up a part from Pinwall and see that they had dyno'd the bike before dissassembly.

http://www.pinwallcycle.com/ebay/bike2399/bike2399dss.jpg

90HP/ 159 ft lbs

Wonder what kind of mods the PO did to pull those #'s :biglaugh:

I'll be darned! Never heard of PinWall doing any dyno runs.....or not releasing them anyway.....that's some pretty serious torque, right there. unk:

 

[one2dmax]

Based on the parts taken off that bike I would say their dyno is severly in need of calibration.

 

[MoPure]

I thought the most impressive thing was the engine rpm. Did they take parts off, or did they fly off? 65,809.33 rpm wow, mussa been a turbine or sunt'n

 

[KJShover]

I was browsing around on ebay and pulled up a part from Pinwall and see that they had dyno'd the bike before dissassembly.

http://www.pinwallcycle.com/ebay/bike2399/bike2399dss.jpg

90HP/ 159 ft lbs

Wonder what kind of mods the PO did to pull those #'s :biglaugh:

The 90HP was pretty close, cause someone torqued the rear axle to 159 ft/lbs :biglaugh:

 

[2stangs69-91]

they show dynos for bikes on alot of the parts they sell on ebay. I bought a drive shaft from them right after my clutch mod lol. and there was a dyno on that bike.

 

[RaWarrior]

Tsk tsk tsk... all you people are so backward. Pinwall uses a state-of-the-art new dyno system and personnel highly trained in the use of it.


Here's a leaked photo of how they create dyno graphs:

Aluminum powder and plastic knobs are the future of precision performance measurement. The bike is set up on a dyno platform as usual, but an Ohio Art trained tester sits in a folding lawn chair in the corner, typically with a Busch in one hand and his nutz in the other. As the bike runs it's course, the trained tester listens and observes and creates graphs, which are then scanned into a computer, and overlaid with a generic dyno readout to fool people and keep their technology a secret.

 

[Heretic]

I was browsing around on ebay and pulled up a part from Pinwall and see that they had dyno'd the bike before dissassembly.

http://www.pinwallcycle.com/ebay/bike2399/bike2399dss.jpg

90HP/ 159 ft lbs

Wonder what kind of mods the PO did to pull those #'s :biglaugh:

Could it be the world's first V-Max diesel conversion? That would at least explain the HP/TQ numbers. :rofl_200: