Strong enough to support the Max?

[Maxin]

Hi everyone . Wondering if more people have ever lifted the vmax by placing the lift under the exhaust and lifting? I do t know where to place the lift b/c the exhaust if lower than the frame! Any advice is appreciated . :worthy:

 

[dannymax]

Everything you ever wanted to know about the subject Maxin! :biglaugh:

http://www.vmaxforum.net/showthread.php?t=33452

 

[Rusty McNeil]

Its plenty strong. After markets too.
Issue I had with aftermarket is it's not a level plane under there because if the twisty on the rears and difficult to get a level lift.

 

[Miles Long]

Hi Maxin-
If you're a measurin', cuttin',and nailin' type of guy, you could make something like this. The rails catch the frame, the inner pieces conform to the profile of the oil pan, and the cut out allows the jig to clear the sidestand bracket. The pipes do not take any of the load.
The jig is sized to fit a standard motorcycle lift.
And by the way....welcome to the forum!
Cheers!

 

[Rusty McNeil]

Hi Maxin-
If you're a measurin', cuttin',and nailin' type of guy, you could make something like this. The rails catch the frame, the inner pieces conform to the profile of the oil pan, and the cut out allows the jig to clear the sidestand bracket. The pipes do not take any of the load.
The jig is sized to fit a standard motorcycle lift.
And by the way....welcome to the forum!
Cheers!

Love it!

Thought about something like that but was too lazy to act on it....