Swing and rim mod

[Hoffa65]

This just might work

 

[Fire-medic]

If you're looking to run a larger diameter wheel with a wider diameter bead then I suggest that you do a relief where the OEM drive shaft side swing arm has a bit of an indent and make that indent larger so that the wheel will have plenty of clearance for the wider rubber.

 

[Big"A"]

If you're looking to run a larger diameter wheel with a wider diameter bead then I suggest that you do a relief where the OEM drive shaft side swing arm has a bit of an indent and make that indent larger so that the wheel will have plenty of clearance for the wider rubber.

Who does the widing of the rims . Either 17 or 18 in

 

[one2dmax]

We can set you up with either for a gen 1. A modified stock wheel in a 17x5.5 or 18x5.5
Email me at [email protected]

 

[Hoffa65]

Anybody offset the swingarm to the left .500 inch?
Is there enough room without hitting the frame?
Would this cause the drive shaft to bind? Running the longer Royale swingarm, should reduce the DS angle a smidge.

 

[Hoffa65]

Custom Triple trees are done for 49mm forks tubes, these things are a thing of beauty .
bearings and seals came today, on to the fitment