- Rand-5107
------------------
Sender Information
Userid: 4798
User Name: Rand-5107
What is your name?: Rand Reddick
-----------------------------
Request Information:
Award ID: 2
Name: Nice guy award
Description: Forum user who always helps out a fellow VMaxxer
Recipient...
I've been trying to donate to the forum through paypal with my Amex card for a couple of months now. When I do it says I can't use this card. I've paid Prez in Europe and Gary here with Paypal and this card recently. Anyone else have this problem?
My manual calls for 85lbs of torque. Cass asks for 1/2 of factory. That would be 42 1/2lbs. To line up my cotter key I either can run 40lbs or 62lbs. How much is to little and how much is to much? Right now I'm at 40.
Last night I finally mounted my Carr.wheel up front. It wouldn't spin due to the fact the rotor bolt on the right side was contacting the fork tube. It wasn't by too much as I could force it by. On the left side (speedo drive side) there was .070 inch clearance. The bolts are titanium low...
Does anybody know if the spacer in the rear wheel will come out either side? When I knocked the bearings out a few months ago I dinged up the spacer a little. I actualy called carrozzeria and asked about buying a replacement, because I wanted every thing new when I put it back together. They...
Ok here's how I finally got my new boot on, after destroying my new paint job again .Put the boot on your swing arm. Drain hole down. Put retaining spring around the front where it (rubber boot) goes over the middle gear carrier. Line up the joint of the spring half way between the top and...
Has anyone successfully matched up any other u-joint for the vmax? I'd like to change mine while it's apart, but I'd rather just buy a u-joint. Not to have to buy a yoke and pay for the caps, bearings, and retainers separately. Dealership was $160.
I bought a set of wheels a while back. They were blue anodized carrozzerias and my bike is red and black. Well to me that just doesn't go together to well. So I deceided to have them chromed. I had to have the tires removed. I went down to Cycle Gear and asked how much to take off the tires and...
I need to replace the o-rings on my coolant drain valve, but I can' t find a part #. It seems Yamaha wants to sell me a $65.00 assembly instead of a two dollar o-ring. Anybody have an o-ring part number that will fit?