When installing my ignition advance circuit I removed 2 wires from the pressure sensor connector to clean stuff up a bit. Stupid me...I forgot how two of the wires go. It's a 3 wire connector and I removed the hot wire (red/white or red/black for late model) and sense wire (black/red). Could someone check to see how there's is wired? Here's the connector configuration:
X
Y Z
I know x is black/yellow. I'm pretty sure Y is red/white and Z is black/red. I checked my Clymer but the pressure sensor test diagram doesn't match how they say it's wired so I'm not sure which is right. Thanks.
X
Y Z
I know x is black/yellow. I'm pretty sure Y is red/white and Z is black/red. I checked my Clymer but the pressure sensor test diagram doesn't match how they say it's wired so I'm not sure which is right. Thanks.
Last edited:
