Search results

Alright so 9 goes on top of 8 and Lays there like in picture, nothing holding it in during installation?

8, 9 and 15 were not installed on stator when I disassemble.

Thanks Cap, Next question, how and where to install shaft, part#15?

Not really sure where these go. Is it number 9 on schematic. I bought number 8 on schematic because it was missing when I removed stator and figured I better buy 9 and 15 also . When I removed generator case things kinda fell into case and 9 was one of them.Top one is the old.

Mine is a 2021 rated at 165HP and about the same for torque. I do have aftermarket exhaust. I know when I finish riding the Vmax and jump on the Rocket there is no comparison. But at the same time I think my Vmax is not running full power and that's why it's in pieces. Just finished rebuilding...

Lmao, I could not imagine it being turbo. This bike is a beast. People say the 1200 vmax will keep up with the Rocket, no F'ing way, I know from experience. Takes about all my arm strength to hold on when she is wide open. She is heavy though and you have the massive fuel tank between your legs...

Definitely get the Rocket. I love mine. Extremely fast, smooth as a cadillac..

Yes, believe it was part#36 from carb schematic Medic. The o-rings and gaskets fit good from K&L. Still have 3 carbs to go yet. OH almost forgot the rubber caps on jet block, they just fall out, sitting here laughing to myself.

I ordered a new one from Partzilla. Punching them in and out a few time kinda mushroomed where needle goes. The ones from partzilla should be good, correct?

I'm rebuilding carbs for my 88 vmax. I purchased the K&L 18-2879 carb kit. I tried replacing float needle and seat. The new needle valve seat pushes right out with a little pressure after I install it with a punch making sure it's seated. So I break out the micrometer and measure the width of...

Lmao, same here.

Hope it comes with directions.

Just spoke with Sean about that. My controller is gone too. I'm going with Ignitech CDI kit.

When I removed stator they was no part# 8, 9 or 15? Don't know what you mean about fiches, you talking about the schematics? Got my new case and ready to assemble, not sure where 9 & 15 go. HELP

Are the stator different also?

They should all be large screws Medic, but I just tried to assemble and they are stripped out even the 1 stator screw I tapped yesterday. So I'm looking for a new case and I found one in the U.K. so that is ordered. I need a schematic of the 85-92 vmax generator if anybody knows where to find...

I'm working on putting new stator in vmax but noticed that the case has heli coil in the screw holes for the pick up assemblies, so instead of having M6 screws it has I believe are M2 or M4. I had to tap one of the screw holes for the stator as when I removed case from engine I noticed only 2...

Thank you, omw to hardware store.

OK, next problem with the money pit. When I removed generator case from engine I noticed only 2 bolts holding stator on to case. Looks like I need a tap. Looks like m6 or m8.

I ordered a new one