block

I was putting my exhaust back on and I was tightening the last exhaust header and I was using a long extension because it was hard to reach. I was getting close to tight and I hear s snap and then the nut was kinda loose again. I took both nuts off and looked at both block bolts and the...

I've got every bolt bolt removed, that yoke/joint thing pulled (where the drive shaft attaches), pistons and oil system are out, etc. For whatever reason, I cannot get the top and bottom halves of the block to separate. Is Yamabond #5 really that strong? I've tried a dead-blow hammer, prying...

Hey, New here and I joined because I just purchased and 86 vmax.:eusa_dance: But I have a very odd carb question. The bike ran great but after a while, it started to backfire when I let off of the throtle so I figured it was ready for a rebuild on the carb since I was not sure of what the...

Hey guys, getting ready to tear into the carbs for cleaning and was wondering if when I remove the jet block is it neccessary to replace that gasket or can it be reused if it come off intack. Thanks

http://www.youtube.com/watch?v=yjWAyouSI8w&eurl=http://www.starvmax.com/Forum/VMax-Pics-and-Vids/29676-exhaust-clip.html

Thought I had an oil leak at the front section of stator cover, changed middle gear and stator cover gaskets - guess what - it was still leaking - washed the engine off - started it up and laid on the ground to see where it's leaking. I would have never guessed - it's leaking at the mating...