coolant

I've looked through the other posts and have done some searching but I can't find a good 'How Too' or Tutorial on flushing the coolant system on my max. I don't know when mine was last flushed as I've only owned it for < 2 months now and based on the condition of the other fluids I don't...

Royal Purple Royal Max Cycle 10W30 coolant: LP Performance any comments? Thanks Ron

I see coolant (anti freeze) on the outside of the motor. I see it on the lower right side. Just a little bit maybe 10 drops or so of coolant is lost. Just trickles down a few hours after I shut motor down. Checked level of coolant. ok When I explained this to a local yamaha dealer they told...

I need to replace the fill Coolant fill cap on my 96 max but I can't seem to find it on a parts schematic, does any one know part number or what I can replace it with. Thanks in advance.

Ok, so strangely enough i've never actually done a coolant flush on any vehicle i've owned. I want to do one on my 03 max b/c i think its never been done (5/6 years)... When i first got the bike, it seems like it never really got 'warm' enough (i know, a very odd complaint) and the thermostat...

As part of my quest to turn my bike into EFI and to mount the TBI,one of my ideas was/is to use the rear of the airbox to mount the TBI.So the question is has anyone moved/swapped /replaced their coolant bottle somewhere else?Does the bottle have to be above the radiator cap?Is it possible to...

I'm looking at replacing my water pump cover with a clear cover, but don't want it to look green. Anybody use the Red Toyota antifreeze "Not Dexcool" in their bike without issues.:ummm:

I'm new here at this forum. I have gotten a lot of good information from here and it has helped a ton rebuilding my engine. Thanks I just got finished rebuilding my motor last night. Today I put oil and coolant in and it started right up...

is there a place that sells coolant hoses all packaged and ready to go? or do i have to order them individually from yamaha? hose 1, hose 2 etc...... which leads me into: what did the mexican fireman name his two sons? hose-a and hose-b thanks...................neal

I am about to replace the coolant in my vmax. The manual says to remove the side covers off each cylinder then pull out the rubber plugs. I'm having problems with this. i remove the cover and behind i can't figure out how to get the plug out. it has a threaded metal center and a rubber...

just wondering if any you guys add any product to the antifreeze to help w/ the hot running vmax. i know some people like to drain it and run w/ water and say redline waterwetter, but i dont want to drain the coolant. thanks