cops

Here's what I have, 1997 Max, stock cdi, I used early 2000's r6 coils (mitsubishi). I did the rear COPs first, started the bike to make sure it all worked, and it runs fine. But I have no tach reading. Then I did the front two COPs, and still no tach reading. Any suggestions? Thanks.

Well I got pulled over for failure to obey a traffic signal at least that's what he wrote me up for instead of illegal turn on red. So no points (thank god) but still sucks I got a ticket. At least he didn't see me a few minutes earlier, lets just leave it at that

I bought a set of short COPs off a 05 GSXR 1000. I am ready to wire it up but I am wondering if I need some inline resistors. My bike is an 86. The COPs are reading 10ohms across the primary connections and 13.5Kohms across the secondary connections. Thanks!

Hey everyone,Im a newbe with a question.I just purchased my first Vmax which came with UFO 4 into 1 with the megaphone pipe.It sounds awesome to me but was wondering if many people here who have them or have had them have been stopped by the cops for loud exhaust? is it possible to bog the motor...

I wonder if this is 'CopRunner's' Euro cousin? :biglaugh: http://www.youtube.com/watch?v=E_PsCFj9bDw&feature=youtu.be

So the PO had Knology Hotwires and Splitfire 416c plugs in. I am now switching over to the COP's setup. So now going from resistorless plugs to plugs with resistors correct?? My other questions are: Which spark plugs should i use with the new denso COPs? Whats your suggestions on running...

I'm not really an "electronics" person so this is my first attempt at solving an issue I have with COPs and T-boost not working. I measured the resistance of OEM coils and got 3.0 ohm, the COPs I'm using have 1.5 ohm resistance. Does that mean I have to find a 1.5 ohm resitor and solder it to...

Just read an interesting article in MacLean's magazine entitled "Too many cops?". http://www2.macleans.ca/2011/08/25/too-many-cops/ Canadian crime rates are falling yet police forces continue to grow. Blaine

Hi guys, I am going to attempt to install the COPs mod but just read that I might need an inline resistor. I have a 1989 model Vmax and I purchased a set of coils from an 03 GSXR600 and harness from 05 GSXR750. Will I need an Inline resistor? (I read all the posts on this but it gets confusing...

Does anyone have this mod for sale? Any advice on the right plugs and wire harness where to find them would be very helpful! And what kind of prices should i expect to pay... :ummm:

i recently swapped over to cops in my 05 using a harness that i bought off here. dont remember who (but it had the resister) the coils came from an 07 gsxr 750. first i wired up the front cylinders backwards and realized something was wrong when it backfired stupid loud a couple times( common...

Installed COPS kit from gannon on my stock 85 max. Now the max takes a long time to start. With my original coils it fired right away. Once running it runs fine. After riding I have a hot start problem if shut off. Have done the direct wiring to the battery. Possible starter? It is original...

so i installed the new kit from gannon (by the way how ******* top notch is his kit? wicked professional!, not just a bunch of parts in a box, instructions (22pages worth), sealed packaging. i was impressed)... anyways got the kit, everything went in easy, the front harnesses could be maybe 1"...

Hey guys I have denso cops I purchased from ebay.I know there is a member on this site that sells plug and play harnesses for 70-80ish bucks i think but if your like me I enjoy building and researching my own stuff when possible.So with the help of the net I can tell u the denso pigtail end of...

If I've posted this in the wrong heading, my apologies in advance. I've been using the search feature to research the COP mod and before I go into info overload I thought it best to just ask a couple of questions. 1) Which coil sticks are the best for the conversion (which bike, which years)...

:eusa_dance:I left my house on the max.GET to the road i was turning on.:damn angry:Two punk kids pissing around in the road when they get out of the road.I grab a hand full of the go stick.The tire is smoking im sideways grab 2nd then third then guess who the f^#%ing cops.HE turns around im...

I have the dyna 3000 with the cops,,but ive been trying to figure out where to run the tach line..I wont give me accurate readings on the coil leads so where else can I grab one from? Does the dyna have a tach line?

I have read through all I can find on the cop upgrade and printed out the list I found for what fits. I found a set of Denso from an 04 gsxr 600 but the list I have doesn't show these as ones that fit. Has the list been updated and will these work?? Thanks Duke

Every single set of cope I have from denso it reading 1.3 ohms...Ive read countless times of everyone getting 1.8 with there densos so why does everyone I test come up 1.3??????

Ive read that the Mitsu cops are not good with the dyna 3k system...Is there any truth to this???Can I use them???Whats different about them and the denso ones?? These damn ones I ordered were supposed to be denso..