fuse

ok. have a '92. just put aftermarket turn signals on it. the aftermarket signals are only single filament so i capped the running light wire and hooked up the signals accordingly. worked great!... for two weeks. now, i keep blowing the 10a signal fuse which also leaves me without a brake light...

so again i post with another eletical gremlen, if youve followed my posts you know that ive been having the issue of my ignition switch not acting right such as not killing the power to the bike in the off position and the easiest way around this was to pull the fuses when not in use. well...

Hey guys, i need your help. Last week I switched out the stock indicators for the halogen 'Vmaxicators' and tail/brake light for an LED swap. The problem I'm having is I keep blowing 10A fuses in about 10-15 minutes after i turn over the bike. I dont think it has anything to do with the rear...

I was helping my friend change out his stock turn sigs on a ZZR600 to some smaller aftermarket LED sigs. The swap went fine. Turned the bike on once we got everything put back together, hit the right turn sig and it worked fine, left one worked fine as well. Went to go hit the right again and...

I having a problem with the fuse for the fan, it keeps blowing when the fan should be kicking in. I'm thinking there is a short somewhere?correct, if not what should I be looking at, to either test or replace. Thanks, Ron :cheers:

Anyone know where I could locate one? Part Number? I checked the online parts houses: Ron Ayers, BikeBandit, Partsfish, etc and couldn't locate this part in the fisches. I talked to the 19 yr old parts guru at the local dealer and he couldn't find it on his puter (therefore it doesn't exist!)...