info

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. slowpoke

    carb sync info

    i received my carbtune yesterday and decided that since its been about 3000 miles ( pretty sure its been longer than that even) since i re-synced i opened it right away and got busy. i know vaccume can often tell how efficient a motor is running so it got me to thinking. how much vacuum per...
  2. D

    Info please

    When I turn my ignition on I hear the fuel pump but dont see any fuel in the filter. I might get a little bit but not even enough to fill the filter up half way. The pump should fill the filter up right? Should it hold a certain presure?
  3. VMAX1260

    Sean Morley- Vmax surgery doctor i need info...

    OK MY BIKE IS 1300cc JE PISTONS , CARRILO RODS. STAGE 1 HEADS. I WANT TO SQEAZE ALL THE POWER I CAN GET FROM THIS ENGINE. I NEED INFO FOR CAMSHAFTS.. I KNOW THAT ARE STAGES THERE TOO. I HAVE MY BIKE MOVING EVERYDAY. SO I NEED A SETUP FOR EVERYDAY RIDES BUT POWERFULL. I DONT KNOW MANY...
  4. 65fury

    New info on my carb problem

    Okay so after talking to a yamaha mechanic, ive been told my needles arent stock(even tho they are non adjustable) they have Y299 stamped on them and according to yamaha mikuni only put letters on the stock needles. Which also leads me to believe that my springs probably arnt stock either. So...
  5. odieoh24

    contact info for marks pipes

    does anyone here have the contact info for mark. had a little accident on climax and need to have some new cans made for the hmf setup i used to have. all i need to replace is the right side can but if he cant match whats alreasdy there then i'll hopefully be able to get him to do a right and...
  6. Heretic

    Carb slide info everyone should know

    If your carb diaphragms seem to have shrunk a little after having them off the bike for awhile, and this is preventing you from getting a good seal with the carb covers, then soaking them in gasoline for about 2 hours might expand them enough to seal correctly again. This tip comes from...
  7. T

    Bike info

    Does anyone know who bmannon is,I'am looking to get a hold of him, to get info on a vmax he has for sale.contact me at 937-935-1101 tony
  8. vegetta58

    scoobyvan info

    Are these lights up to par? They are listed on ebay.I've seen one that I like better but its daggum $400. These will do just fine for the money if they are quality. Also has anyone installed his temp. sender lowering switch? Ive only had my bike since this winter and I dont like how high the...
  9. vegetta58

    v4 Garage info

    Does anyone know why the IMG is off on my v4garage page and how to turn it on? Thanks for the help:ummm:
  10. KJShover

    Boxenstopp fighter tail info

    I was needing some pictures of the tail mounted, side and rear please. My unit came in and I'm working on assembly now. How did you get the rear brake light mounted in place? License plate mounting. I'm trying to make sure I've got all the parts.
  11. joelyons50023

    Stock cams info

    I know that this question has been asked before but i was just wanting to know about the stock cams timing specs and lifts also the rod length. And also sean you said that thou can be milled from the block is that for the lip of the sleve to make it b/c i think that is gonna be the route that...
  12. max_caper

    Vendor info wanted: oldbikebarn.com

    Just saw some parts I want to purchase on a website called www.oldbikebarn.com I never heard anything about them and I was hoping for some feedback. Thanks, Blaine
  13. Maximum

    Star's 2010 Max info site.

    The opening vid is a bit over the top, but the rest of the info is interesting. Thought I'd post this in case some of you haven't squandered your stimulus money and have twenty large or so still laying around. http://www.starmotorcycles.com/star/msite2010/micro_v2010.aspx
  14. I

    Need some info on pegs

    I need to get some forward mount pegs that I see on some of the bikes in the gallery section. I am tall, 6'2, and need some more leg room. What do you suggest and where can I buy them.
  15. D

    Tail Light Integrater info needed...

    Somebody had mentioned that they were using an electronic integrater that allowed the rear turn signals to be used as running lights and/or brake lights. I did a search but it must be buried in a thread somewhere. Anyone out there familiar with such a device and where to buy it? I know Kuryakyn...
  16. nosvmax

    Wow so much info

    Wow I must say I am overwhelmed with all the information this site has to offer. Its addictive I find myself always coming back and reading more. I have a few questions though I hope no one thinks I am dumb I am just learning about the VMAX. So far everyone has been super dooper cali frag a...
  17. Scaryfast

    Need info on my differential

    I would like to improve my fuel economy on my VMAX. On long rides I'm only getting 90 miles on a tank. I was thinking I could rebuild my diff with venture parts fairly cheaply to lower my highway rps. What would the fuel savings actually be, and would i be money ahead just replacing the whole...
  18. gleno

    Fazer Info - Help Needed

    I know there are some fans of the FZX 750 Fazer who live in this forum and I need your help. I have the opportunity to buy a well priced low kms Fazer for my next project. I want to build the bike pictured and I'd like more information about it. I have seen a similar project bike on the net...
  19. Birdoprey

    Interesting timing/pickup info for 85-89 V-max

    There are two VR sensors, each with TWO individual pickups. Each VR sensor is mounted 70deg from the other. There are two triggers mounted on the flywheel, each 180deg from one another and each is physically off-set from the other. One rides on the inside edge of the flywheel and the other rides...
  20. M

    I'll start.... Any info on this exhaust system?

    Looks interesting as exhaust will be the first mod I probably do.
Back
Top