relay

Hello Guy's after 3 years customizing again inside outmy bike i am installing all the wiring now and stuff. on my bike i have a Hid kit 8000k one ballast for Low beam And one for High. on my bike i also have aftermarket horn which needs a relay to work. my mechanic installed 2 relays one for...

engine turns but won't start, gas ok, spark at plugs ok, starter relay ok , checked the resitance on the starter cut-off relay got zero, the manual says 225 ohms, could the relay let the starter crank the engine but not make it start

A bit of a longshot but Rick & I have worked a deal on what's left of # 211 & were trying to get it to Florida on a slim budget. Actually I am not picky if I could even get it to the Knoxville TN area or Houston Tx. area I could eventually pick it up from either of them 2 places. If any one is...

I'm working through the charging system on an 1986. So far I need a new stator, a new voltage regulator, and a new or rebuilt starter motor. I have a new battery that shows over 13 volts when fully trickle charged but when I turn the key on there is this clicking sound that cars make when the...

As always with my mod and how-to write ups, a little speal divulging the inspiration: The bike was acting up every once in a while when I'd go start 'im up. Figuring it was another electrical gremlin, I started measuring voltages. Long story short, I found a broken ground terminal. Don't...

So I fitted these nice LED blinkers I got from the guy who sold me my larger tank and rear mudguard. They came with resistor packs ( I think that's what they are) that connect between the bike harness and each indicator. They work good and are very bright, but my blinker relay seems to have a...

Is there a difference between the older (85-89) and later models relays? Looking at the electrical diagrams listed on this site..they look the same..want to be sure before buying used

My problem is when fuel gets low light does not come on and pump does not cut off so I essentially run until empty with the fuel switch to ON not reserve. How do I check for proper function of relay? Bulb and sensor check OK

Im firing on 3 cylinders. Front right no spark. Coil ck ok, plug wire ok, connectors tight.... What is this? A relay? its marked 4U8-01 ONRON 1625D9 How do I ck to see if working properly?

How can i tell if my fuel pump relay is bad...and where can i get a new one if that is the case? Thanks. 86 Vmax

Hello, I am looking for a LED flasher relay that match the OEM 5 pins connector, is it available?

I had a question about a fuel pump relay operation from a member and had a unused VMax fuel pump relay, so I dissected it. I hope this wasn't sacrilegious. Not sure how the Omron component in rear works. I did a search for it and didn't come up with anything definite. Pictures are just for...

So after dealing with a melting contact armature for the fourth and last time, I said eff it and decided to tear the whole ignition out and replace it with some kind of keyless mechanism (thanks Saml01 for the inspiration). Yes Yes I know--why not find out why the contact arm is melting in the...

I started up my vmax yesterday and had it running in the driveway and the bike just died like someone turned it off. Now it will not start. The engine turns over, but will not start. I'm looking at the side stand switch and side stand relay, but the wire colors in the service manual do not match...

I had the rear coils off for a while, now I can't remember which wire goes where. Does the positive lead go on the left pole or the right pole? Thanks.

This info is intended for people who have at least a basic knowledge of electronics or can understand a schematic to create a circuit. If you build this, I take no responcibility if after fitting, it fails and frys your wiring. It is for this reason that I'm not offering to make them myself...

I think mine is bad, I wanna bypass it. So how do you bypass the kickstand RELAY on a 1985 Vmax?

Has anyone disected a signal light relay pack or otherwise found out how the internals work? Anyone draw up a schematic?? I've done the LED conversion and have the fast blink rate like everyone else. I've tried adding resistors in series in both legs of the left and right signal light circuits...

ok i have an 85 max bought it new has been a great bike no problems , 20 k mile no major mods, has been sitting lately but i fire it up every once in a while and ride it a bit, so it had been sitting i rolled it outside chargerd the battery, a little bit of starter fluid and it fired righty up...

For the past couple weeks I've been trying to track down an issue with my fuel pump. I was getting current to the fuel pump relay, but not out to the pump. So, I replaced the fuel pump relay. Now, I'm getting current to the fuel pump, but it's not clicking away as it should (I disconnected...