replacing

Hi:punk:, I need to replace my stator. I have been looking at an older thread posted in the "How to" forum called: Replacing your pick-up coils, and I had a couple questions about it, but I'm worried that nobody will read my posts on it because it is an older thread and my questions are at the...

Hello guys, i took my ride for a spin i made about 300 Kilometres after my big investment usd forks with gsxr rim front, rear max daddy ufo rear wheel 17' bored to 1300cc in TTS performance with carillo rods and je pistons. my bike was very quick but i noticed that when i reached 219 couldnt go...

While my new tank sealer in curing I decided to drain out all the old fluids and replace them. I did the radiator the day I got it and now there's nothing but nice neon green stuff in there. My next question is, does this thing have an oil filter? What about a dip stick??? I found where to put...

Little bit of reading Ive done, this seems to be somewhat common on vmaxes.....Anything I should know before getting into it? Mine doesn't make a whole lot of noise until about 2500 rpm..Just sounds like a hammer tapping on the side of the engine.... ________ R27

Hi All, I have a 90 Vmax with an 'old style' shift segment that's probably about to fall apart and want to relace it with an 'updated' version - anyone have a shortform description on how to do this? Thanks David:ummm:

Thought I would post for interests sake. Kinda what I do for a living. A spectacular failure on someones planetary drive out of earth moving equipment. Options are to replace with factory replacement parts usually at huge cost or come to someone like us who specialize in the industry. We have...

Is there a step by step guide for this?

I bought a stator cover off ebay and I want to use my stator in the cover I bought.Is there any timing issues to worry out or just r/r the stator Thanks for any help

Does anyone have any quick info on replacing these covers? Easy/not easy? Gaskets required or not? etc... Thanks...

I'm new here at this forum. I have gotten a lot of good information from here and it has helped a ton rebuilding my engine. Thanks I just got finished rebuilding my motor last night. Today I put oil and coolant in and it started right up...

can the rear be replaced without pulling a ton of **** off? This is my winter project (along with new exhaust gaskets)

Over time the rubber tubes that hold the carbs and V-boost together and form part of the inlet manifolds age, crack and leak air. Yamaha originals are expensive but there does not seem to be anything remarkable about this tubing. No special fittings or fixtures With the variety of after-market...