running

Hey all, I'm a newby to the group and just got my first VMax - Stock 02. I recently installed a 4-2-1 Kerker and K&N air Filter. I was able to get it up on a dynojet at a local bike rally and the chart showed I was running very fat espically at lower RPM's (3000-5200) and was still at 11...

I got the Weber carb. sync. tool you guys recommended to sync a bike with Stage 7 and there seems to be no ryme or reason to how this thing is adjusting. Shawn Kloker was nice enough to PM me a quick write up advising me to set the idle around 1100rpm's, use the screw on the left to sync 1-2...

I have read almost every post on the site and haven't found a definitive answer to this problem. My newly purchased 1997 with stock carb/exhaust/air filter runs fine when first started. As it warms up, it starts running rougher and rougher. When at full operating temp, it won't idle and runs...

Ok here is the scoop. Been fighting a carb problem for a while now, would not rev past 4k and stumbling all over the place. So I took the carbs apart AGAIN, and did the following all float levels set to 1.075" dry wet level 17mm +-1mm with the 152.5 jets, 90mm pilot jet on the top of the...

I have 96 VMax with 23,000 miles and no modifications. My problem is after the bike warms up and i take off, it seems to lose a cylinder randomly. it will surge and pop out the exhaust and in to the air box. but after about 5 miles it goes away. then every once in a while it will pop in the...

What pads are you running? And which are the "best":angry flame devil: Stock EBC HH Galfer Green or Black Other

I will get this bike ironed out eventually, I HOPE! Put new plugs in a few weeks ago after the 2 left ones died. Max ran awesome then! Then the other night I started it up to let it run a bit and noticed it wasnt sounding right again. A quick touch of the pipes found the left cylinders were...

Hey guys, I'm new to the V-Max scene and I think I have a problem. My bike starts and runs smoothe, but I think it is running on 3 cylenders. I changed the spark plugs to OEM and still runs the same but a little bit better. All of the plugs that came out looked ok, no white plugs or oil. The...

Running On 3 Cylinders... Just yesterday my 85 vmax seemed to lose power and after futher checking I found that the left rear cylinder isnt working. I pulled the plug..... excessive amount of black carbon build-up on it. (NEW NGK plugs all the way around.) I cleaned it and reinstalled...