setting

I'm 6' 212lbs, I'm not running the bike at the strip or anything, heck I'd rather the rear wheel spin like hell, Just showing off & haveing fun. Thanx all, Shorthair888...................

Ok , well this is strange - has any one had this problem , and if so what is the fix -- i have set my floats as per the dry setting thread, all is well, however twice after sitting the bike for a week one float has changed its setting so high , it allows gass to flow out the overflow on top of...

If I want to make sure the settings on the mixture screws are correct, how many turns out should they be? I want to make sure they are correct, since I messed with them the stumbling and crappy performance has become worse :bang head:. Thank you in advance.

Just found out that some tool has been working on my bike. One membrane was not in its groove an one needle layed in the trottle. Got about 20 horspowers more when I fixed it, but low rpm mixture is way off. Idle-screws are out 5? turns. The needles was set to its lowest possible setting, that...

Ok, here's what I've got Racetech springs and emulators. 15wt oil and 1.5" lowering spacers in the rebound portion of the fork. I also have the forks sticking about 1/4" above the top of the upper triple not counting the screw on fork cap. I was running 11" progressives in the rear, I...

Alrighty folks... I finally received the wheel from UFO today... It is a 6.25" wide rim with a 180mm mounted on it. He didn't set the bead because it makes installing it much easier. Unfortunately it also is near impossible to set the bead since this small of a tire was never designed for a...

Set for 1.125 inches to get a 17 mm wet level. Picture courtesy of Icepick. Mark #1098