slide

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. M

    flat slide troubles maybe

    I have a 1985 that I just got a couple weeks ago. I has flat slide carbs they don't seem right Bike sounds great after it warms up. You put it in gear and it sound like it bogging down almost a like a sucking sound then the bike picks up.It seems to be strong in rest of gears just the...
  2. i_was_here1st

    Carb Slide Diaphragm Questions

    Hello, i was recently enjoying a lovely, legal ride down the street, obeying all the speed and traffic laws like a good little citizen, when I noticed my max seemed to be running a little boggy. Several minutes later, at home, I pulled off the airbox and notice one of the Slide Diaphragm that...
  3. Rusty McNeil

    Russian article on US slide to Socialism

    I think this deserved it's own post. Here it is. http://english.pravda.ru/opinion/columnists/107459-0/
  4. daves86vmax

    slide diaphrams

    has anyone here used the slide diaphrams from python?they're only 63.00,about 27.00 less than oem that i've seen.
  5. T

    carb slide question

    I have a couple sets of carbs. One is a stage 7 set. They have the hole in the bottom of the slide drilled slightly larger than stock. What will that do if I put it in my stock carbs with stock needles? Also there are 2 sets of springs. One is longer than the other. Which is stock and what will...
  6. R

    Slide diaphragm repairing

    the carbs i recently bought have bad diaphragms... so i was looking for a cheap fix and found this guy on the ebay...
  7. P

    Replace fork slide bush or guide bush?

    I?m in the process of replacing leaking fork seals on my ?97. Everyone?s advice to use an impact wrench worked well. I?ve read what I can and it seems that most people are simply replacing the oil seals. But, the on-line service manual (under VMF Links) says the following on pg. 6-31: If you...
  8. S

    hole in back of slide

    I bought a replacement slide and the hole is smaller than the ones i have installed. I know i dont have a stage7 mod, but would anyone have any ideas on what size bit is used in the mikuni and dynojet kits i could always just pull out the dremel a bit, but that could get risky
  9. D

    Flat slide carb questions

    I'm about to buy my first max. I have a line on a bike that has Kiehen(spelling) flat slide cards and is using the stock airbox and after market pipes. I don't know what kind of air filter yet. I believe that this is the only engine mod and was done by PCW in NY. I'll be using this bike as a...
Back
Top