small

Hola! As stated .... 5 foot 6 inches, 150 pounds. Flattraker/jockey sized. In the mid 1980s I had a Harley FXRS. I traded in my Sportster XR1000 for it ... HUGE mistake. Bike was too big for me. Everything sucked ass. I changed the seat, bars, footpegs. Seems no matter what I did the...

Got a chance this weekend to add a couple small cosmetic mods, added the small alum blinkers I got from Sean, small LED tail light I got from Motorcyclemods.com and the Extrap Vstacks I got from Mr Pickles. It sure tightened the bike up a little, and I swear the Vstacks added 10 hp.:biglaugh...

hey guys, didn't know if anyone is good with small engines, specifically pressure washers? picked up one from my grandparents which had been sitting for a few years. to my surprise the engine runs well, starts right up and doesn't hiccup, stumble or anything. can start on 'run' after being...

Anyone have a suggestion on where I can find a small re-usable container that can hold 2-4 ounces of fuel additives like seafoam or a similar product? :confused2: Item will need to have a leak proof seal as well; any suggestions appreciated.

Well as the title says! "for crafty guys that have small fingers'' or even guys that just want to give a good attempt. Years back Yamaha had the paper 1st gen Vmax you could print out. Well looks like they finally released the 2nd gen Vmax.:clapping...

Hey guys I changed the oil last weekend and noticed that the bottom of the flywheel cover was leaking oil. It is not enough to leave more than a drop or two on my garage floor when she's sitting for a couple nights, but I would like to eliminate it. I put a new gasket on the cover when I...

hey everyone, new to the site, also new vmax owner.. i just bought an 06 with 5500 miles. i took it for a 120 mile ride, had to stop once for 5 min. for road construction. noticed the temp guage rising, when i got home, i noticed a few drops of green coolant on the lower right side. upon...

Hey all, I would like to get a smaller than stock turn signals all the way around for Max, as the large lollypop looks kind if dated...but worry that people behind or meeting me on the highway won't see me. I had a set of small blinkers on a Gixxer I used to run, and unless you were riding...

Somebody has way too much time on their hands. Got any cool small stuff to show? http://www.youtube.com/watch?v=i3VVI6Auvys

so, today i was going for a ride and decided to head up to a car/bike show about 60 miles from home. got there, and was the only non-harley in the show. it wasnt a judged show so i just went to show off my **** and hang out. seems the hot rod guys have quite an appreciation for a quality...

Have an 04 Vmax. Was installing the K&N air filter. When I had the stock filter out, I noticed a small, thin layer of gas in the front left of the air box when sitting on bike (so closest to clutch level versus throttle). Is that ok? If not, what could be the cause and is this something I need...

No, I don't mean to shake yourself into a speed wobble or an accident. But I would like to know what your bike does and if it is stock or modified as far as suspension is concerned. If I do this, the front end continues wobbling at 2 or 3 times per second for a few seconds until the wobble...

I'm new here and to the V-Max. I just bought my first one this winter, a 2003. I'm very very happy with it! I really like the look of the naked bike, but I'm finding myself looking for places to put things such as wallet, night vs day glasses, etc. I'm trying to find an inconspicuous bag or...

So my craftsman mower won't start. It has a B&S 16hp engine. So far I have replaced the battery, starter, solenoid. The same issue remains. When trying to start , the starter engages but the engine only does a partial turn then stops, it is still trying to turn over but won't . I have...

just wondered if anyone would have one of these chrome caps that live on top of the 40mm front forks - one of mine fell off while I was riding.. I still have the rubber part that sits in the hole, I just need the actual cap. Anyone with a spare one lying around?

http://www.youtube.com/watch?v=WKUD6sXNxQg

I have a '99. I'm doing progressive springs and oil & dust seals. Everything came apart fine but............in the inner fork tube, just above the Oil lock piece there is some sort of retaining ring. It doesn't seem to be mentioned in the on-line repair manual. I noticed 2 or 3 small pieces...

Don't know if this is the right forum for this question. I have seen a larger aftermarket screen for the small (about 10" tall) factory instrument cover windscreen. It is taller and wider. Anyone know who makes it or where it is available?

quick question, I'm trying to order a set of 155's BEFORE I attempt taking them apart....I understand there are two types of Mikuni round jets....do I need " small round " or " large round " mikuni jets. P.S Do i have to remove the carbs from the bike to change from the stock 152.5 to the...

I finished my valve cover gaskets last weekend. And All week long I've been doing routine maintenance, oils, air pressures, torques, few minor tweeks and blaah blaah blaahs... Well tonight I fired her up for about 5 minutes then rode over to the driveway, about 100 feet. I didn't rev it just...