thing

Good thing there's things to keep me busy. Just got done routing a neck for a cigarbox guitar, and laminated wood for a neck and marked it for routing for the truss rod. Just have to figure out the body and head design and what pick-up are going in it. Pulled the instrument cluster of the...

So I did a wheelie over some train tracks last night and I heard POP GRIND GRIND GRIND from my drive line the second I whent to do it. I hope its not a transmission issue, theres been NO problem or noise leading to this point but now it wont put power to the ground at all. it just revvvs up...

1. It uncomfortable 2. It's ugly 3. The guy that thought the fuel access was big enough has hands the same size as my 8 year old daughter 4. Guy who designed it was probably not on their A, B or even C design team. Might even work in the mail room 3 days a week.

I found in my new rack of carbs that one of these things, no clue what it is, is sticking out. Here's a pic of what I'm talking about, however this is from my spare rack. It's that thing the needle in the diaphragm goes into. One of the carbs on the bike has one of these things sticking out...

I was thinking about a supercharged engine, then a turbo motor. So then I thought, why not a twin turbo engine ( a couple of you were already in the loop) I've already bought two turbos, that will be set up for 5lbs of boost. I just bought 2 blow off valves and a pipe kit to make the exhaust...

So I tested my side stand relay. Found it to be bad. Here is the weird thing. Bike will run, when put in gear, side stand down, WITH THE RELAY REMOVED. No need to jumper the wire to the ignitor.:ummm::ummm::ummm: Any ideas on why. I dont have my clutch switch wired cuz I have the FJR...

A couple of guys were arguing about who had the faster harley. After about 2 hours of longcocking they decided to put up or shut up and race. They lined up at the street light and waited for it to change. As the light flickered to green, a thunderous sound of engines revving filled the air as...

knew i was in need of a new rear tire so i ordered one up from the motorcycle superstore(69.99)+1 bottle of barbecue sauce to hit the free shipping total:biglaugh:75.94 shipped to my door.I just looked at it a little closer and saw this thin spot,guess i'll wait for the tire before i take it...

I PULLED INTO A 7-11 GAS STATION THIS MORNING TO GET GAS. I WAS APPROACHED MY A GUY WHO ASKED "THAT THING SOUNDS SO GOOD, IS THAT A HARLEY"? I SMILED AND SAID "YEAP".:bang head::rofl_200:

OK Went to start up and I've started getting loud backfires the past couple of times when I hit the start button. started and ran for about an hour on the highway..cruising at 70ish..all of a sudden loss of power (power did not cut off though, RPM drops to about 1000), then a loud backfire, then...

What to use ... sand , pellets , liquid . Do i buy online or is there something that can be used thats just as good . What have you guys used ? :punk:

E-A-G-L-E-S Eagles Eagles Eagles yea baby:clapping::th_image003:

I found this thing in my rubber gas "funnel" the other day and I'm scratching my head. it is u shaped, about three inches tall and 1-2 inches wide, with a lip or hook in the center section. any thoughts or ideas? i'll try and snap a pic later. TIA..........................Neal

I hate to be a killjoy BUT.. Having had a chance to look at close up pics of the new V-max (taken by ROB06 in the thread titled ' Sitting Tall Haha Ha Ha Ha') I was wondering how much is thing is going to cost if it goes on its side :ummm: There seems to be a lot of very expensive bits...

Another thing wrong Went to take her out for a ride.Started her up and let her idle for about one minute and she died?:confused2: Won't start now. The pump stays on for about 5-7 sec. even after cycling the key about 10 times. Took air filter cover off and swirted gas in all 4 carbs and she...

No..it's not what you think, so get your mind out of the gutter!! LOL! Well, after 2 1/2 years of ownership of this current bike, (it was in dry storage for 2 years) I broke down and washed the filthy pig for the first time since I've owned it. :clapping:Needless to say, I think it turned out...

but kind'a mean too. http://video.google.com/videoplay?docid=-8371471915481077005

http://youtube.com/watch?v=oHg5SJYRHA0...

hello all, i have a 2006 max and there is a stainless wire on the left rear carb with a loop on the end .it looks like it should hold a hose in place,yet nothing is there . it really looks out of place .i know that the new maxes all have them.i hope somebody can let me konow what this thing is...