venture

Anyone need these? $35.00 delivered to the lower 48. Thanks, 501-520-8211 Yes, i bought out an inventory of Vmax parts and i need to make room in the garage. I am also building another Vmax. Yee Haw!!

Found this cheap in local adds website...

I have a 1200 Venture and I'm in the process of doing a 17" radial swap. I'm grafting the venture center hub in to a ZX7 rim and am at the very early stages. Unlike most Venture touring bikes, mine spends a fair amount of time on twisty fast roads and I like draggin' aluminum and steel in the...

Ok, I am ready to bury my bike with a backhoe!! It started running like the idle jets were plugged up. Erratic and low vacuum readings on the Morgan Carbtune. So sinc the carbs had never been off I decided to do a rebuild. Pulled carbs and used an ultrasonic cleaner on them. While cleaning I...

What your guys opinions on a 2008 venture with pipes and other accessories? I was thinking about getting rid of the 03 Vfr the wife doesn't think it's comfortable at all. I went to get my bike inspected by my local yamaha dealer buddy he has this on consiment it's a 2008 with 31k asking 8600...

So the Max is sold and I have an opportunity to get a smoking deal on a 2007 Yamaha Royal Star Midnight Venture. Bike has approximately 40K miles and is clean. Anyone have any info on these bikes, the good the bad and the ugly? I know it's not an FJR but it's a Yamaha, and it's a V4, and the...

Here how it was 3 years ago fairing was craked Carb diaphragm craked ans all seal dry out At the first try out of basement the fckn starter clutch wen out :damn angry: Mod the 2003 air box to fit the new carb Project not finish yet, this will go on next winter

This is on another site: http://www.m109riders.com/forums/showthread.php?t=276890

Hi All, I am new to the Forum but not so new to life and bikes in general. I have a 1986 Yamaha Venture that totes a Motorvation Formula II sidecar that could use a little extra in the HP category. To that end, a VMax rear gear assembly was installed and does improve the takeoff and excessive...

Long story short... My VMax engine started having a bad knock after runing dry, I layed the bike on its side (had an accident) and with throttle stuck WFO and no oil circulation... Bike also suffered some cosmetic damage, those are fixed, the engine got the worst from the accident.. well if I...

What year venture engine (1300cc) is normally swapped in to a Vmax for a HP increase?

Hy, -After 2 years of home improvement the 1986 royal venture project is back on the track. -I teared all off to get it lighter (fearing and lugage wash a bit mashed) -A little bit of Vmax DNA on the faux thank -The fuel level float was unusable so i replace it with a non contact level...

Looking for length of 1st gen venture rear brake rotor. Need something about 12 1\2 to 12 5\8. I think its the same bolt pattern as the vmax.

The engine in my V Max started to make a bad knocking noise. I guess its the main bearings... I have found 2 Yamaha XVZ Venture engines. These are basically the same engines, correct? So, could I use the bottom end of the Venture engine and just bolt on the V Max , rods, pistons, heads, cams...

Helping sell for a friend. Located in Indiana. Super clean! Sharp dresser with low miles. Always garaged and taken care of. New tires and brakes, with Harley pipes gives it a great sound. Pictures do not do it justice.. Just dont ride it so selling it. PM or [email protected]

Is it possible to put Vmax heads with their bigger valves on a 1300 Venture block without major issues? What mod are required? Notching pistons?

Venture engine with Vmax carbs..tuning? A guy from the french board put a Venture engine on his Max but with the Vmax carbs. At 5000 RPM (WOT or part throttle) it fall on his face. I suppose carbs settings have to be modified. If somenone knows this settings or at least stock Venture carb...

aney body fited an 86+ venture gear indicatour to a vmax ?:ummm: should be a straetford swop

Just found out my 15 years under a tarp 85 Vmax with the broken oil filter boss also has a broken crank. But two years ago I picked up an 83 Venture that was in a house fire, most of body melted but other than the cdi being bad which I found the engine runs great, I am kinda new here and I can...