VS Bullet
Active Member
Does anyone make a hose kit for the 1st generation V-Max. I'm thinking if I order them piece by piece from Yamaha it might get a little expensive. I noticed one of the carb boots is cracked also, so I might as well replace all the rubber around the carbs to.
This is a 1988 model that hasn't been maintained. Evidently it has done a lot of sitting around the last few years. It was tough to get the oil filter housing off, then the bolt out, thought someone had welded it on, but it was just the old rubber.
Everything looks oem, I suspect its normal to start replacing all the rubber? Probably already should have been replaced.
This is a 1988 model that hasn't been maintained. Evidently it has done a lot of sitting around the last few years. It was tough to get the oil filter housing off, then the bolt out, thought someone had welded it on, but it was just the old rubber.
Everything looks oem, I suspect its normal to start replacing all the rubber? Probably already should have been replaced.