I should have known this would be a problem

[gamorg02]

Thanks, I think I'll bring one of the bolts I have to a place that sells bolt and see if they can tell me the exact size. This place doesn't carry the bolts with the flange so I am goign to try and find some somewhere.

you don't 'need' the flange, you can just use a washer and be fine, that bolt doesn't have tons of pressure on it.

 

[EAGLEPI]

True, I was going for the look but I guess a chrome bolt and washer will give the same look.

 

[gamorg02]

True, I was going for the look but I guess a chrome bolt and washer will give the same look.

yea the bigger ACE around here has a really nice chrome metric section....

 

[EAGLEPI]

I'll be going bolt shopping tomorrow and I will check out the ACE we have here... I'm sure I will find something that will work. I am still amazed that Mark offered to just send me a set of new cans no charge... what a guy!!!

As I mentioned in a post a while back I found out that a guy a block and a half away from me has a 92 VMAX and he loved the exhaust I have so I am going to really try to get him to buy a set from Mark.

 

[PATMAX]

Since Mark is sending you new cans, it makes my fix a moot point. Kerker 4-2-1

 

[EAGLEPI]

I wouldn't go with Kerker over Marks anyway....

 

[Redbone]

I've been bending a shifting for hours and I can't get them to fit so the bolts go thru. I just talked to Mark and he is sending me out a set on new cans. Damn it's nice to see someone who takes care of the customers that way.

I had to elongate the bolt hole on the RH sideto get the bolt to go through properly, but only by a 1/4" at most. Here a couple pictures of how close my cans are to the shocks.

 

[satariel666]

M10x1,25 - 70mm lenght

 

[EAGLEPI]

thank you

 

[dannymax]

I had to elongate the bolt hole on the RH sideto get the bolt to go through properly, but only by a 1/4" at most. Here a couple pictures of how close my cans are to the shocks.

Looks to be the same as mine Brian....about 1/4" or so.