LSL steering damper info

[wildweasel_pt]

Hi all
Does anyone have fitting instructions or pictures of this setup? The one that has the damper underneath left scoop protruding from below. Thanks in advance.

 

[VMax-Mike]

This is the one me and leecifer had on our bike's. you will need to cut/trim the plastic trim near your frame so one of the clamps will fit. not a big deal and to replace the trim peace would not cost much. If you take your time and do a nice clean job trimming it you wont even see it. other than that all you need to do is play around with the adjusting. I don't know if i had it installed the way the instruction say to because i got it use and did not have any. But before i installed it when i hit 132 mph i had a very small slight vibration and after i put the steering dampener and a set of shinko tire's on i could take it to 150 mph with no vibration nice and smooth. Imo i think the shinko tire's are the best all around tire for the bike. the speed rating fit's the bike good and the bike corner's nice. But if you are a Beekeeper kind of guy and love to do brake torq and rolling burn out's than metzler is the tire for you. I have had a metzler on my bike and it did have a slight shake at 130 mph with the steering dampener but i had a shinko on the front so maybe miss match tire tread at that speed.

http://www.ebay.com/itm/Shindy-17-4...0e918d6&pid=100338&rk=2&rkt=5&sd=301705871268

 

[benjamin]

I will take some pics tonight
Becarefull clamp on frame side will break very easily at wire cutout .
Not much of a difference on first few settings.
There is a couple far pics on bike in for sale section
Danny

 

[VMax-Mike]

You can go into my gallery under 2002 all blinged up and see a pickture of it installed

 

[VMax-Mike]

i also found this it should help

http://www.vmaxforum.net/showthread.php?t=23362&highlight=steering+dampener

 

[wildweasel_pt]

i also found this it should help

http://www.vmaxforum.net/showthread.php?t=23362&highlight=steering+dampener

That's not the lsl unit Mike. I'm talking about this one that protruded from underneath the left scoop

 

[VMax-Mike]

Thinking back to what i did on the daytona install unless you have more parts im not sure the lsl will work. you must have a part that goes with the frame mount. The frame is a tube so not sure how you would get the mount to go around the tube with the bolt hole's the way they are. Not saying this don't go to a vmax but im not sure it will.

 

[Dorney]

That's not the lsl unit Mike. I'm talking about this one that protruded from underneath the left scoop

That looks like the 1 that goes in between the triple trees & the gauge cluster. If I was to get 1 that would be it nice clean mount.

Dave

 

[wildweasel_pt]

This one is specifically made for the vmax by LSL. I already have the fitting instructions courtesy of H at Exactrep. But i would like to get some pictures of how it sits on the bike as im considering fitting this one on the bike im going to install a charger and im concerned i won't have clearance for the charger snout as it seats under the left scoop as well.