My Mods thus far...

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Marc85

Active Member
Joined
Mar 8, 2014
Messages
41
Reaction score
0
Location
Denver, Colorado
Bought my 07 max stock apparently it was a California model that someone removed the Cali. garbage upon purchase.



What I have changed:
UFO Dragstar 4-2-1 single slash cut exhaust
Changed main jets to 155.
Removed Y *may put Y back on when it gets colder here.
K&N single OEM replacement filter.
Iridium plugs after AF screws adjusted post jet change.

Koso RX1n Gauge

Stainless braided break and clutch cables

LED accent lights still a few more to add (outdoor rated from hitlighting off Amazon)
Head light

New front and rear LED blinkers.
New LED headlight from these guys: http://www.ebay.com/usr/the_parts_shop?_trksid=p2047675.l2559
Specifically this light: http://www.ebay.com/itm/400655177341?_trksid=p2059210.m2749.l2649&ssPageName=STRK:MEBIDX:IT


Just lost 2nd gear so here are the mods to follow:

Morley undercut gears w/ od 5th
Replace all seals and gaskets while engine is out.
Oil pressure gauge, anyone have tips for a digital to go in place of the old tach?
Check/ re-shim valves (I'm at about 18-19k miles anyway)
Exact rep parts:
Magnetic oil pan plug
Oil temp filler cap
All new radiator hoses (green of course)
Engine case cover stainless bolt set

All new trim pieces are being painted Tacoma Magnetic Grey Metallic

FUTURE MODS

Exactrep already purchased:
New fluted tank cover
New short LED brake light short fender
*Damaged upon unboxing***

???? Front radials w/ hyabusa forks????

Transmission WIP 1/13/15
https://www.dropbox.com/sh/hsfdo9mibfqsik2/AACErsgQ9bxEif3ITIjDz2GNa?dl=0
Bad shift drum and linkage...
Take all my money VMAX :(
 

Attachments

  • 1270176_525621679748_841020513_o.jpg
    1270176_525621679748_841020513_o.jpg
    83.9 KB
  • 2014-09-30 20.13.37.jpg
    2014-09-30 20.13.37.jpg
    76.5 KB
  • 2014-09-30 20.14.40.jpg
    2014-09-30 20.14.40.jpg
    52.8 KB
  • 2014-09-30 20.14.04.jpg
    2014-09-30 20.14.04.jpg
    40.6 KB
  • 2014-09-30 20.16.18.jpg
    2014-09-30 20.16.18.jpg
    52 KB
  • 2014-09-30 20.14.53.jpg
    2014-09-30 20.14.53.jpg
    46.1 KB
  • 2014-09-30 20.17.25.jpg
    2014-09-30 20.17.25.jpg
    31 KB
  • 2014-09-30 20.20.58.jpg
    2014-09-30 20.20.58.jpg
    35 KB
  • 2014-09-30 20.20.23.jpg
    2014-09-30 20.20.23.jpg
    51.2 KB
  • 2014-09-30 20.16.50.jpg
    2014-09-30 20.16.50.jpg
    52.9 KB
Last edited:
I usually put it on the center stand and put a floor jack under the oil pan with a board for that one, lol. Nice bike!
 
The shift segment isnt a big deal, especially when yiur doing 2nd gear anyway.
it might be a good time to fit Seans hi volume oil pump modification, and make sure you get his upgraded oil line o-rings!

You have a nice bike. I lkke what you did with the headlight and Instruments! :)
 
Back
Top