Transmission How deep

[Arkymax]

My trans is locked up and I am going to have to split the case to repair it. Can I just go in frm the bottom of the engine or do I need to do a major dissasembly Pistons rods ect? Im hoping I have a broken fork.

 

[[email protected]]

Poston, rods, crank, cams can all stay in place

 

[Arkymax]

Great got the motor out and am going in from the bottom tomorrow

 

[one2dmax]

Yep, flip it on it's top and take all the covers off (valve covers can stay on). There are a couple of retaining straps you need to remove and plenty of bolts so make sure you get them all.

Sean

 

[Arkymax]

Got the right and left covers off, the clutch out, water pump out, oil pan off, slave cyl out. Do I need to remove the flywheel and driven gear to take the trans out? Found a piece of shift fork in the pan. Also found a small spring and ball bearing when I took off the left cover but can't figure out where it goes to. It's not the ball bearing at the end of the slave cyl. rod.

 

[one2dmax]

Sounds like broken bearing in the trans. Flywheel can stay on.

Sean

 

[Arkymax]

Thanks Sean, Got it apart and it is a brokern fork. It look like it destroyed two gear sets also. I'm going to sit down tonight and figure out what parts I need.