Vacuum advance port. How to drill & tap

[dannymax]

Re: Vacuum advence port. How to drill & tap

i think the general consensus is to weld some thicker material on the intakes and tap them there

or to do what danny did.

Yeah, Holley & NOS say the best spot is in the intake runner....maybe for the best mixing....:confused2:

 

[Saml01]

Drill the intake and use JB Weld as the thread locker. Done.

 

[rebar]

Drill the intake and use JB Weld as the thread locker. Done.

+1

This stuff is even better.. Actually the 603 or 609
http://www.google.com/products/cata...a=X&ei=vyVoTc6vA8mgtgfy643mAw&ved=0CCgQ8wIwAA#

 

[rebar]

Re: Vacuum advence port. How to drill & tap

Yes,

here's what we did on the nitrous fittings.
http://www.facebook.com/pages/Morle...et=a.301308358678.147336.282702488678&theater

Almost looks like we welded washers on them but it was a build up of metal and reshaped, then drilled/tapped.

Sean

Im trying to eyeball the location on your ports so if I ever install nitrous Im good. Thanks for the picture Sean.

 

[rebar]

Drilled and tapped them. I found that I had at least 5 threads of depth which seemed enough with the 1/16th npt fittings.

 

[dannymax]

Nice....Stealthy! :clapping: 5 threads should be plenty, there's no pressure trying to push them out, just the opposite, actually. That set-up will work great! unk: