This is my first post, before writing it I searched the forum and maybe I didn't look properly, but I didn't find the solution.
I'll explain my problem. When I bought the Vmax, I took it apart piece by piece, cleaned it, painted the frame, engine and rims , changed all the engine gaskets, adjusted the valve seats and then adjusted the valves. The engine was perfect. The carburettors were cleaned and the gaskets were changed. The engine runs perfectly, sounds perfect, but it doesn't run well in the mid-rpm range.
I know the problem is with the carburettor needles, the bike runs dry in the mid-rpm range. I changed the position of the needles from P3 to P5 and it improved a little, but it still fails in the mid-rpm range. Right now I'm wearing the 5DZ19 needles, I also have the 5EZ50 and 5EZ43 needles but the last two are not adjustable in height, they only have one clip position. I have also tried them and the problem continues.
I have seen different needles on the forum, and by the shape they have, I think that the ones I should install are the Dinojet Stage 7. Do you think that will solve the problem?
Remember that my bike is European, it has a 2EN engine with the Vboost system installed. At low speeds it runs perfectly and at high speeds it runs like hell, it seems like it will tear your arms off. The high and low jets are the European standard.
Thank you in advance.
I'll explain my problem. When I bought the Vmax, I took it apart piece by piece, cleaned it, painted the frame, engine and rims , changed all the engine gaskets, adjusted the valve seats and then adjusted the valves. The engine was perfect. The carburettors were cleaned and the gaskets were changed. The engine runs perfectly, sounds perfect, but it doesn't run well in the mid-rpm range.
I know the problem is with the carburettor needles, the bike runs dry in the mid-rpm range. I changed the position of the needles from P3 to P5 and it improved a little, but it still fails in the mid-rpm range. Right now I'm wearing the 5DZ19 needles, I also have the 5EZ50 and 5EZ43 needles but the last two are not adjustable in height, they only have one clip position. I have also tried them and the problem continues.
I have seen different needles on the forum, and by the shape they have, I think that the ones I should install are the Dinojet Stage 7. Do you think that will solve the problem?
Remember that my bike is European, it has a 2EN engine with the Vboost system installed. At low speeds it runs perfectly and at high speeds it runs like hell, it seems like it will tear your arms off. The high and low jets are the European standard.
Thank you in advance.
)
