I will be installing this vrod led headlight. I just want to confirm. Per the pic, the low beam and high beam are two separate connectors, so I will be cutting those. So I should just connect the VMAX green wire to the low beam red and the VMAX yellow wire to the high beam red and then attach all the black grounds to the single VMAX black.
Just waiting on the Vrod shell to get this done. Will be using side clamps that will fit on my forks.
Do I need to attach any resistors or anything as this will be LED? Anything else I may be missing?
Just waiting on the Vrod shell to get this done. Will be using side clamps that will fit on my forks.
Do I need to attach any resistors or anything as this will be LED? Anything else I may be missing?