What's up guys? I've been away from the forum for a while. My vmax has been in pieces in my garage for the last six moths since I returned the carbs to Sean that I borrowed to help diagnose my problem. That's a long story..... but anyway my coasting enricheners were pretty rotted out so I replaced them. Finally over the last week I've got the motivation to get this thing going again! I got everything together but the problem is the left rear cylinder has to much fuel, I'll explain. It'll start and idle but it's rough and The slide cover (the outside cover or whatever its called) is cold. As soon as I loosened the Allen screws gas started to run out. Also without the airbox on if you look in the top of that carb (left rear) the top right hole has gas pouring out of it. Am I correct in assuming the the float height is off on that carb? Or did I screw something up or forget something when I put it back together. I hope this all makes sense the way I explained it.
Thanks guys
Thanks guys