Barnett clutch upgrade - springs

[royston]

Hi Chaps,
I am considering the above and have read the best stuff in here for guidance but would be keen on any thoughts from anyone who has installed this to advise how they found clutch pull after install to the stock set up eg; if it became much stiffer or remained roughly about the same??
Cheers

r

 

[wildweasel_pt]

Not that noticeable. Not that it may be a factor...

 

[royston]

Not that noticeable. Not that it may be a factor...

thanks for that...i am a bit intrigued by the last point "not that it may be a factor" ???
Cheers
Roy

 

[4gasem]

I have the springs and the plate and noticed an increase in resistance at the lever. Rightfully so as the the springs are quite a bit stiffer than stock. I personally like it over the diaphragm spring. To me, it feels more consistant through the range and less on and off like the diaphragm spring.

Chris

 

[one2dmax]

I have a barnett in my 2 face bike but we have even heavier springs in it. I'd say maybe 20% more then the DD pull is (which is stout).

Sean