Crush Gasket sizes?????

[donnelly317]

Were gonna be tossing some crush gaskets at work and I cant find the sizes for the vmax anywhere. These ones are aircraft parts so all I can do is measure the inside diameter. Can anyone help me out?

oil drain/antifreeze drain size???
Brake banjo bolt size?? I believe there 10mm?
and gas tank size?? ( I drain my tank every winter )


Thanks

 

[wildweasel_pt]

Oil is 14mm iirc, same as final drive. someone correct me if im wrong

 

[donnelly317]

I got 22mm, 10mm, 18mm ones. I believe the banjo bolts at 10mm and I think the fuel drain may be the same size

 

[davesax36]

I agree on fuel/banjo swap. I'm pretty sure I just did that switch.

Sent from my Galaxy Nexus using Tapatalk

 

[Rusty McNeil]

I can't really answer your question.

But I've picked them up in various SAE sizes at auto parts stores and have done fine with that so I do not think the sizing is "super critical" as long as they fit without too much slop.

They ones on the upper oil tubing, the middle gear cover lowest bolt, and the upper rear engine case bolt the heads are probably most critical on sizing I would think.

 

[dingy]

Below is a link to a thread that shows a McMaster Carr substitute for the brake crush washers. They probably have the others you mentioned also.

http://www.vmaxforum.net/showthread.php?t=17606

Gary

 

[wildweasel_pt]

And those work fine as i re did my brakes 2 weeks ago and they held perfectly.

 

[donnelly317]

found the oil drain is 14mm McMaster Carr has 16mm. Ill grab theses 18mm from work and see how they look on there.. I acquired 50 10mm ones though for free