Ted J
Active Member
I know you don't want to do it with the diaphrams for the slides and just clean the needle and the coasting enrichener you just clean the metal on it as well, and obviously the o-rings you wouldn't want to either. But what about the rest of the metal parts, like jets and the such?
The carbs themself I'm going to clean them one by one and clean them as best as possible as I can and used compressed air to blow it out but wanted to know about the metal parts if letting them soak for a few hours would be bad or if I should just clean each part one by one, blow it out with air etc...
Thanks!
Ted
The carbs themself I'm going to clean them one by one and clean them as best as possible as I can and used compressed air to blow it out but wanted to know about the metal parts if letting them soak for a few hours would be bad or if I should just clean each part one by one, blow it out with air etc...
Thanks!
Ted