Search results

Yes, much patience is needed and really thankful for the wisdom. I will loosen the front again and use mallet / jack method. I realize muffler work on the ground with just one person is difficult and requires ingenuity. Both rear pipes did great. Front needed 3/8-1/2 inch more. I have very small...

Took it out for a ride, leaks a little, not bad. Will seal it with high temp rtv. Bike runs awesome. You were right, 2dmax and Fire-medic bike runs like it should. Twisted throttle a little to much and back tire started singing sweet medley's. I love it. Thanks for your help. The time people...

Got it as good as I could, will it leak exhaust, most likely as the penetration on the front pipes was not good. Maybe a half inch at best, they just would not go any further and I followed your steps on muffler installation. Thought I read a thread on the forum about someone who said they were...

10-4 on the inner slide hammer. That might work but, they are so soft and as you say delaminate / fall apart easily. Splitting them with hacksaw blade is a good option. Either way is not going to be easy. I'm also seeing a extremely close fit like it might be too short. Hoping this is an...

Thanks for that gasket knowledge. Did not realize rear cyl's had 3 different types. My issue is the stock muffler that I bought appears to have -44's already installed in the holes and my pipes have them installed on them as well. Don't know how you would get them out of muffler so I guess the...

Just spent most of the day trying to install stock muffler, could not figure out why down pipes would not fit. I think there are bushings on the pipes as well as in the muffler. So limited in parking lot with no air or power. Thinking that removing the down pipes and taking them to a shop to be...

Voo doo ranger is awesome beer.

Sean, thanks for your help and your video's ! My bikes previous owner removed center stand attachment brackets with a cut off wheel. There is a small square box shaped piece with hole in the bottom that is welded to the frame. I'm hoping that's where the center of the muffler attaches and holds...

Yes, I have this part coming but not sure it fits my 2000. Now searching for Yamaha part #'s 1FK-14638-00-00, Collar / 1FK-14747-00-00, Damper Muffler / 36Y-14747-00-00, Damper Muffler. These items are on back order or discontinued. I need a miracle or a little engineering technique here to...

Trying to find the last piece's to the puzzle on my stock muffler install, Part no longer available. Damper is a rubber grommet that is placed inside center point of attachment on muffler assy. Thanks for your help. John

Gen 1

Cobra Slash Cut Slip On Mufflers for sale. $150 plus shipping

10-4 but, I got a deal. Shipping will still be better than a grand.

Should have caught that one !

ARE THEY STILL AVAILABLE?

This was actually my first vehicle. Great memories, that truck was awesome, floated across a creek bed with it.

Is the muffler still available?

I would also like to say thanks to Sean Morley for incredible video's, fixed my steering and added air to forks, different bike until no.2 float stuck, but no worries banged it with screwdriver. No seriously carbs are coming I know that much. And everybody's opinion is welcomed and appreciated...

Thanks Fire-medic, just tried to cancel order. Wish me luck, truth is I'm on disability and have no business spending a grand on pipes, then carbs. New in the beginning that it needed to be stock @58 but it pulls amazingly well. Only can imagine what Parminio described, maybe screaming. If I get...

Thanks for the much needed advice, that's why I purchased the Drag Star 4 into 1, will get back after install.