carbs

Hello, Can anybody give me detailed instructions concerning the use of the carbtune II on a vmax. I've tried to find some on-line, but can't seem to find any links that are still valid.

I'm having a motorcycle mechanic re jet my carbs on Friday. Is there anything else I should have him do while he's got the carbs apart?

HI im having problems with my vmax and cant get it to run correct , after months of pulling my hair out after numerous ideas on what it could be and it still boils down to ( its the carbs ) so many people hav told me iv also posted on this fourum vboost room subject- vmax wont run without...

Hey everyone new to the forum and loving it just bought a vmax last week, its a 96 been doing a lot of searching and decided to post. I had a dead spot in my throttle 2500 rpm to 3000, if it were getting no air or gas just seem dead but when i gave it more throttle it runs fine, was also...

The other day I had the air box off to try and get the carbs down in the boots better. One boot is always wet. After a bit I got it a little better but the carbs still don't want to sit down well. If I get 3 in well and try to get the 4th, the opposite corner pops out. After messing with it I...

Hello, I was wondering about what I could expect to pay to have my carbs cleaned and synced?

I just bought my first motorcycle (that runs and drives). I accidentally left the key on yesterday while hanging out with my daughter and the battery went dead. I am also waiting on a screw for the clutch lever perch, as that snapped off right above the threads. So the bike is in the garage...

I have a stock 2004, it does have the v-boost switch to kick in at 4 grand. The bike runs rather rich, can smell it when you stop. Milage is near 30 to the gallon. I don't want to change the headers, pipes or air filter for more power. I am interested in doing some carb work to clean up the low...

what do the carbs look like when they r actually working? i had the air-box off the other day 2 clean the bike properly, and started the bike up 2 look thing over and looking into the carbs from the top they werent moving much (on idol) even when i turned the accelerator they didnt do much, i...

Picked these up on fleabay yesterday....what d'ya think? http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=370495131242&viewitem=&sspagename=STRK%3AMEWNX%3AIT

I have Vgas carbs and a friend of mine said I should have the line coming from between the cylinders should run out the back like a overflow hose and the one with the breather that goes in by where the oil fill is should be towards the front to push fresh air into the motor insted of the two...

i am selling my cv carbs with filter box and K/N filter. I have fcr's now and i dont thing i am gonna use the mikuni anymore. 350 + 50 shipping. full working condition . you may have to change the main jet to stock size cause i had 170 mian jets for my bigger engine

Hi all, I've finally got around to the business of tearing my Vmax down for total rebuild this extended holiday. I've got it stripped down to the point where the carbs are ready to be pulled (lower clamps removed, throttle cables disconnected at the disconnection point) however the carbs will...

tommorow i will run a duno. i recently installed my fcr's which work great. i was trying to find some dyno's numbers to see what will i exepect with my 1300cc engine but no luck. does anybody run a dyno with 1260 -1300-1325 engine and fcr's carbs ? ?

I'm finally pretty satisfied that my carb adjustments are about as close as I can make them. Since there are no covers for the Air / Fuel Screw Holes, I wanted to do something to seal them against moisture entering or Fuel / Air leaking. I keep everything that is left over from any job so I...

When all of you are complaining about having to do carb work on a Max just look at these & go back thank your Max about how easy it is to work on. Yall are lucky you dont have to take the exaust off & the chain & one side of the handle bars loosen the fairing so you can get to the top motor...

So I got this 85 resto project sitting dead in the water needing carbs because I have no cashola on hand so it would have to be a trade deal or at best mostly trade and some cash. Of course the newer the better. If you got a rack sitting doing nothing, shoot me a reply. I have lots of chrome...

Guys, sorry, couldn't tell if this was an appropriate place to locate this thread. Either way, I have an 86 Honda Rebel 250 that was running fine last summer... it was real cold blooded but would eventually get over it and warm up and run well. I let it sit too long and it had a hard time...

Okay well im finally back after my month long vacation........ and im ready to get this bike running right!!! So lets recap... my bike ran good from idle to 4k then sputtered and ran like crap till 6.5-7k so i added another spring to my slides to slow them down from opening to quick and i was...

Yup...free, you pay the shipping. I bought these about 3 months ago and got screwed. The bike had been submerged under water. The insides are rotton and rusted. I salvaged the floats and all 4 rubber diaphrams. All the linkage is intact. These carbs are non rebuildable. So if you need some...