gauge

I installed my new carb boots and now my temp gauge is not working...could I have knocked something off or loose? Blown fuse? Thanks, Abe

I have a 1.5" oil pressure gauge that I want to mount to the handlebars. Can't find any mounting hardware. Does anyone know of a source for mounts that can be used to mount the gauge to the handlebars? Would like a nice looking set-up, not the "double hose clamp" method. Have found plenty of the...

ok

Bought and installed the Cycleoneoff oil pressure gaurge that attaches to the water pump housing. Love it. Works perfect. Hard to read when doing 120mph :) Maybe should have nought the handle mounted version. Would buy it and install it all over again though.

All, does anyone have any experience with choosing a wideband O2 sensor and gauge combo? I want to install one (or make it removable) for dyno testing/setup. I have been looking on eBay and found a few, but I have been hesitant on picking one as I'm not exactly sure what to look for. If...

I Have A 2006 , I Bought It New ( Left Over ) 3/07 ,i Love It !! The First Time I Rode It At Nite, The Gauge's Were So Brite They Really Bothered Me !!!! Especialy The Speedometer Thats In My Face !!! So I Took My Gauge's Apart, Put Really Low Watt Bulbs In Them, And Covered The Bulbs With Red...

Any way of testing the temp gauge, the fan seems to be kicking in at half way 3 Oclock, normally it would only kick in past the half way mark, not sure if it the gauge or something else.:ummm: Thanks, Ron

can i install a car fuel gauge onto my vmax?

I ordered a pressure guage to mount on the handlebars. Just curious...how hard it is to install from the side plug that everyone removes and puts in the gauge? I would like to try to do w/o draining all the oil in the bike because i just did an oil change. Also what pressure should you see...

has anyone ever used one of these or similar to it???? looks like ...if it works....could be permanently mounted. http://www.amazon.com/exec/obidos/ASIN/B000F3IKUE/becomecom-20/ref=nosim or something like this one.... http://www.amazon.com/exec/obidos/ASIN/B00062YBES/becomecom-20/ref=nosim

My understanding is that we place the fitting close to the oil level glass, But this will only measure the general pressure in the crank case below the cylinders and this pressure is actually the back pressure of the cylinders as they go down and not the oil pressure in the oil passages, if that...