Carb Synchronizing - General Comment

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
...next comes realization and even further on down the road resignation!

I forget what comes after that!:ummm::confused2:
:rofl_200::rofl_200::rofl_200:
 
Thanks for the link... I used the carbtune and re did the carbs. Weren't off by a lot but tried to grab for perfection. Very responsive now... Rolling at 20-30mph whack the throttle and lay rubber... Makes me smile:)


Sent from my iPhone using Tapatalk
 
Got the Morgan in the mail today. Carbs were off quit a bit. Big diffetence in Idle and throttle response .
Should the over all readings across the carbs be higher?
The readings seem low compared to others I have seen on the forum.
p1969530998-5.jpg
 
I wouldn't worry about the rod height. Did he just say rod?

Balance is the key and the height will vary based on idle thumb screw setting, valve lash, choke, richness, etc.

Mark
 

Latest posts

Back
Top