Drag Race bike project, gen II

[KariR]

I saw couple of V-max at nitro jam pitlane in Bradenton race track, were you there?

 

[KariR]

The stock gear indicator on/off switch does not support an auto sifter, so build a linear one.

 

[one2dmax]

Why won't the original one work?

 

[KariR]

A Break between the studs confuses the ECM, it didn't reconize which gear is going in. All sifting parameters can be defined for each gear. i can of course use the same parameters for all the gears, but it is not optimal way.

 

[Itgoes]

Interesting.......the Power Commander can be calibrated with the speed signal to know which gear the bike is in.

Do you have a speedometer on the bike......and if so how does it get it"s data?

 

[KariR]

Do you have a speedometer on the bike......and if so how does it get it"s data?

I have front and rear hall-senders connected to can-bus for traction control and some other goodies. Defining an optimal full throttle gear change w/o clutch for each gear is a different story. (Ignition kill delay, ignition kill time, injection kill time, power reduction level, reduction recovery time...)

 

[Woody]

Going fast on a motorcycle is more about shaving weight then it is about making power. You get far more advantages by doing the weight first. The lighter front end, single caliper/rotor/line, homemade brackets to replace the OEM heavier duty brackets, ect...

Sounds like you want a street bike that LOOKS like a drag bike with the second thing being to go fast. Really no different then most guys on here.

Sean

When I raced atv's. I always used heard every 7 pounds you lost. was 1 or 2 hp gained.
you can shave weight from a lot of places.
1.The bike
2. riding gear ( light weight carbon kevlar helmet, lighter boots)
3.the beer gut.

 

[KariR]

Brackets for a better footpeg location.

 

[wildweasel_pt]

****. The layout looks like a wire diagram for such simple parts... Good job

 

[customizedcreationz]

****. The layout looks like a wire diagram for such simple parts... Good job

LOL agreed.....

Looks good though.

 

[Redbone]

Harkening back to my high school architecture class my teacher that when drawing anything everything you build must have a dimension because the builder cannot build if it's not spec'd.
I guess it's true with everything on vehicles as well but that we just do not get the chance to see the process very often. The drawing is cool and now a desktop!

 

[wildweasel_pt]

Today just turn it in a standard cad file and anyone can see the dimensions using a cad reader.

 

[KariR]

The black anodized footpegs and brake master brackets are ready to instal.

 

[KariR]

The footpeg re-location is done.

 

[adambweird]

Nice work!!!!

 

[lowlifexj]

well it cost my company $55.00 for me to read through this thread from post one to the end. I think it was money well spent!!:rofl_200:

 

[jbretthorton]

I would like to know how well your shifter is going to work...... What brand?

 

[wildweasel_pt]

well it cost my company $55.00 for me to read through this thread from post one to the end. I think it was money well spent!!:rofl_200:

Either you read really slow or I want your job.

 

[MaxMidnight]

I would like to know how well your shifter is going to work...... What brand?

Trans Logic - have a butchers here.

 

[one2dmax]

I am a translogic dealer by the way!