Marks 4-2 exhaust pictures needed from underneath.

[customizedcreationz]

Looking specifically for the h pipe area. If you have his exhaust and could snap a few pictures of it from each side and underneath I would appreciate. I want to see what type of bracingcan be done with it.

Thanks
Todd

 

[FootNote]

If you dont get anything by the time I get home I will try and get some.

 

[customizedcreationz]

Thanks!

Todd

 

[SpecOps13]

Stole these from various threads hope they are of use to you.:ummm:

 

[gamorg02]

Stole these from various threads hope they are of use to you.:ummm:

2nd pic is a walker setup.

 

[[email protected]]

2nd pic is a walker setup.

How did you determine that? :biglaugh:

 

[vmaxinID]

No crossover??

 

[customizedcreationz]

Looks like a crossover to me , but up higher and smaller ?

Todd

 

[Redbone]

I can add a couple that might help since I have a Mark's system which has the crossover:
From side/top looking at rider right crossover pipe where it connects just before the pipe.

Another shot from right rear 3/4 view, but probably not a low enough angle to help much.

In this picture it looks like the crossover pipe is more or less equidistant from the tire (Shinko 170 on stock wheel) to the pipe vs. the centerstand mounting bracket to the pipe.

Here are four more I just took, I hope it helps!

 

[Redbone]

How did you determine that? :biglaugh:

It his bike!:biglaugh:
Edit: DOH! sometime sarcasm on the 'net eludes me!:th_hit:

 

[gamorg02]

Looks like a crossover to me , but up higher and smaller ?

Todd

its the frame.

 

[customizedcreationz]

Deceiving picture.

I am looking for pictures for a swing arm setups, so I can start fabbing a swing arm up.

Todd

 

[gamorg02]

Deceiving picture.

I am looking for pictures for a swing arm setups, so I can start fabbing a swing arm up.

Todd

yea it is. i also took a closer look, my 02 bung is perfectly in line with the frame so you do see something protruding from the exhaust there, juts just the o2 bung tho.