Need help identifying electrical connector.

VMAX  Forum

Help Support VMAX Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Tyboy11

Well-Known Member
Joined
Feb 19, 2017
Messages
83
Reaction score
3
Location
DFW
All,

Putting this thing back together and trying to figure out what the red wire/plug in the picture goes to. Connector on left side of bike and runs along the back side of the battery in a small harness to the right side of the engine. It's just a single red female blade connector.
Plug 1 with arrow.jpg

Plug 2.jpg

Any help would be appreciated.

Thanks,
 
Last edited:
It's an 85'. The female plug in the picture is exactly like the female plug connected to the red wire on the starter relay. But that is all hooked up. Just got it back together after 5 years and numerous things are needing rewired after I put some juice to it, so it's hard to tell what's not working. I'm doing some repairs to the other wiring and will try again. Starter didn't motor, no neutral indication and a lot of others, LOL.
 
UPDATE-Keep in mind this is a work in progress....Still no starter engagement and my neutral switch is actually illuminating my oil pressure light. Gonna have to check my connections for that one, LOL. May not have enough juice to turn starter at this point. Battery is junk and I have a charger on it to do these checks.

Fire-Medic -- Thank You for the PDF manual at the beginning of this chapter. That is going to help a lot.
 
Last edited:
Another Update-- My neutral switch and oil level wires (bayonet plugs) were swapped. Neutral now working. Starter tries to engage but battery is too low. Still no turn signals and brake light is on and flickering (aftermarket LED)> I'm going to get a new battery in the morning, and I'll see how it goes.

I still don't know what that plug goes to that I started this thread asking about??
 
Back
Top