Sean's Valve Shim Kit?

[Mr. Max]

I didn't pull the carbs, might be easier though. All valves were in spec, just on thight side so I put in a little thinner shims to get more clearance (loose end in spec), thanks to Sean I didn't have to wait weeks for a new shims!

 

[gamorg02]

i'm impressed you could do it without pulling carbs!

 

[sdt354]

+1

Your going to end up pulling the carbs anyway, really don't want the covers off when you do that or something will end up inside the motor.

+2 , I have a friend. He's been turning wrenches for over 30 years and knew better. He didn't stuff rags down the cam chain channel. Don't you know the cam tool snapped and went right into the engine. He went crazy finding the pieces, but had the good sense to not stop looking till he got them all out. Rags are so cheap!

 

[vmaxman99]

I didn't have to pull the carb rack either. Did have to loosen the fuel pump mount to make clearance for the rear cover.
Mike