Spark plug boots

[Ga2wheels]

My vmax is spark plug boots are in need of replacing. I have a good set from a 97 zx-10
Anyone know if there would be any issue using something like this or do I need to compare resistance on these other boots


Sent from my iPhone using Tapatalk

 

[dannymax]

I would compare resistor values or swap the ones from the VMax caps if they are up to spec.

 

[dannymax]

Per manual plug cap resistance is "approx. 10 K-ohms @ 20 deg C"

 

[Ga2wheels]

Just measured one off the vmax and can’t get any ohm reading at all. Even took the resistor out and tested it alone and nothing.
Would this have even have been firing?

Sent from my iPhone using Tapatalk

 

[Bill Seward]

That's one of those " If there's any doubt, replace" kind of things. Cheap and easy to replace, and could save you problems later. I'd do a set of COPS if it was my bike, though.

 

[D-Max2012]

Ordered these last year.. On the reviews, it's used on the Vmax.. So far, So Good..



https://www.amazon.com/gp/product/B...ailpage_o08_s00?ie=UTF8&psc=1#customerReviews

 

[Ga2wheels]

Yeah the readings were off a good bit. 2 were right on and the other 2 not even close.
Ordered new NGK’s earlier today. I think the Kawasaki ones I have would work but they read 13 ohms. And unsure if the 3 ohms makes any difference. Decided to go new.




Sent from my iPhone using Tapatalk

 

[eggohead]

I ordered and replaced mine a couple of years ago.. Once I can find the correct part numbers I will let you know...

 

[eggohead]

https://www.rockymountainatvmc.com/p/954/35092/NGK-Universal-Spark-Plug-Cap-Straight
They list two sizes, I don't remember which ones I ordered... they are like $4 each....