maxout1200
Well-Known Member
I just installed these today. No ugly brackets. No wires to hide. Clean and simple.
Signals are Lockhart Phillips Razor LED's Part#122-8250
Pigtail Conectors are Lockhart Phillips Part#122-9655 and plug into the stock signal connectors.
Hole is drilled one inch from headlight mounting bolt as shown. Measure from center of headlight bolt to center of hole to be drilled. Hole for signals is usually 3/8 inch to 7/16 inch depending on brand. Drill the holes before removing the headlight/Tac assembly.
Remove the assembly by taking out two allen head bolts below headlight and two allen head bolts above head light. The turn signal conectors are located behind assembly near upper two mounting bolts.
Note: Fork tubes do not need to be removed or dropped to take off stock front signals.
Signals are Lockhart Phillips Razor LED's Part#122-8250
Pigtail Conectors are Lockhart Phillips Part#122-9655 and plug into the stock signal connectors.
Hole is drilled one inch from headlight mounting bolt as shown. Measure from center of headlight bolt to center of hole to be drilled. Hole for signals is usually 3/8 inch to 7/16 inch depending on brand. Drill the holes before removing the headlight/Tac assembly.
Remove the assembly by taking out two allen head bolts below headlight and two allen head bolts above head light. The turn signal conectors are located behind assembly near upper two mounting bolts.
Note: Fork tubes do not need to be removed or dropped to take off stock front signals.