air

I have K&N air filters, the crankcase breather canister or oil/air seperater is connected to the front two air filters with rubber lines. Two larger lines come up from the crankcase and plug into the bottom of the breather canister. I started investigating this because of oil around the carbs...

This is from Mark Knoller of CBS. The pilots and crew of Air Force One are flying more hours than a rookie on a beer run. They are tired of it too, and are adding more crew to Air Force-1, - I know this for a fact because I'm one of the instructors that trains the crews. Our company (Atlas Air)...

I have been reading about them that they need to be used with a modded air box or if running just the filters. I tried searching for pictures but didn't find any. So what are they for?

I have my theory about the stumble when hot issue happens and #1 cause is voltage drop because of extra taxing of electrical voltage dropping and the other is having A/f circuits open too far. As the engine gets hotter the air box being under the faux cover never sees ambient temperature unless...

Good read. http://www.calsci.com/motorcycleinfo/Airboxes.html

Im going to be installing a stage 7 kit in my 2005 max. Was wondering if anyone is useing the max air kit from python motorsports with a stage 7 and does it work well... If anyone has any other suggestions about what will work the best (with a stage 7) my ears are open . I am pretty much...

I just put on my new shinko's and I went to check the front air pressure, but the valve seems too deep for the guage to work. I had to loosen up the actual valve to get the reading. I thought perhaps the valve needed replacing so I put in a new one and same results. Is there something wrong...

How to make your air box fit tight I had trouble with my air box ocassionally popping off one carb or the other making the bike run bad before I discovered it had popped of one of my carbs. I could actually pull the air box off with my hands after all four clamps were tightened. Upon futher...

I just bought my first motorcycle (that runs and drives). I accidentally left the key on yesterday while hanging out with my daughter and the battery went dead. I am also waiting on a screw for the clutch lever perch, as that snapped off right above the threads. So the bike is in the garage...

Looks metal but sounds like plastic I have a 1990 was wanting to know I was going to polish it if it was aluminium any one know and if it is what's the best stuff to use

I have supertrapp open end caps stage 1 jet kit was wanting to know if installing the 4 kn filters and getting rid of the box would help out or not

Does anyone have this system? A bit expensive, I am not likely going to spend the $$ but it looks pretty-well done. http://www.ramair4vmax.com/default.htm An interesting read & Gen II style scoops for the Gen. I as well.

Hi guys, just thought I'd post some pics of the finished air shifter install I did to my 94, big thanks go to Sean for hooking me up on the kit and all the advice! I redid alot of the wiring too, I just didn't feel right hooking a solinoid up off my factory harness so I wired in a relay to...

My carbs require the flue line to be routed down low between the cylinders close to where the oil breather is. This creates a high spot where air gets trapped in my fuel system. Iv removed the air before but its a pain in the ass preventing fuel from spraying all over uncontrolled. Can anyone...

Found an air bag I really like for motorcycles...........

was doing a burn out today on my 85 max (yeahhhh not 2 good for the bike i know but they look good lol) and after i had finished there was oil all over the place over my engine top to bottom. on first thought i thought i had blown a gasket, thankfully not tho. it all came from the line from my...

Hi everyone I was wondering if an air shifter would trash a stock trans? I just updated my shift segment and did the DD clutch mod and was really considering an air shifter too but the trans is stock other than the above mentioned mods, would it hold up or is it a bad idea? Thanks in advance...

I thought I had read in a back issue of a VBoost magazine that someone had substituted a mechanical "preload" in place of the stock air pressure fitting at the top of the front forks. I've gone back through them and cannot find it. Has anyone a) heard of this? b) know anything about it? c) tried...

As most of you know, I've been locked in a seemingly endless battle with the Evil Spirit of my 89 VMax. PATMAX, allisontech, CaptainKyle, Conea01 and a few of the Ladies were present when we cut SkullDuggery's Evil Heart Out... Air Correctors,,,,, I've been asking about them for some time...

This is a topic I have running on vmaxchat.co.uk as well. Notice how the curves on the air scoops are misaligned with the carb disphram covers. Has anyone else come across this before? Thus far the debate is whether the bikes frame is bent, or the carbs are not seated properly. Im convinced...