12V switched feed

[GlosMax]

Good day to you all.

Getting to know my Gen 2 after three weeks of ownership, and am slowly figuring things out, but I can't seem to see an obvious candidate to tap into for a switched 12V feed. I need this, mainly, for my Sat Nav but also my camera and heated gloves.

I have the cowling off and all the wires exposed, so I should be able to find a wire if you describe it to me.

Any suggestions?

Many thanks

Dave

 

[D Larson]

Under the left hand scoop is where I picked up power from the switch. I did not take a picture when I had the scoop off but here is the section from the diagram.

There is a connector there where the brown/blue comes in and the brown goes out. I connected to the brown/blue for switched power.

 

[crynool]

I have a PDM60 under my seat which connects to the running light for activation.
https://www.rowe-electronics.com/pdm60
The easiest would be the taillight as it is close.

 

[D Larson]

I installed the Amplink from them
https://www.rowe-electronics.com/amplink

 

[D Larson]

The switched power is from under the left scoop. I ran a real automotive ground cable to the frame connection on the right hand side of the bike and the positive to the battery.

I have the Garmin and the STS Brake system connected to the Amplink and will be adding a Vantrue F1 camera system next.

https://www.vantrue.com/products/f1